OUTBOARD WINTERIZATION & OIL CHANGE

We add fuel stabilizer, run the engine to temperature, flush with fresh water, fog engine with rust preventive oil mixture, drain gearcase, inspect for impurities and refill  it (crankcase oil and filter on 4 stroke) and change remote fuel/water separator filter. We remove and inspect propeller, lubricate the shaft, and re-install.  We lubricate all engine grease fittings, and inspect and replace zincs as necessary. Disconnect Battery cables, clean and lubricate terminals.  Propeller reconditioning is additional.

OUTBOARD WINTERIZATION, PREVENTIVE MAINTENANCE & WATER PUMP IMPELLER
Includes Outboard Winterization plus… we run your engine and check it for proper function. Remove lower unit and install new water pump impeller and gaskets and inspection of wear plates and housing. We pressure check your gearcase. We check operation of power trim pump, spray entire engine with rust inhibitor, and touch-up paint on lower half.

OUTBOARD TUNE-UP
We check cylinder compression, install new plugs, and replace all engine fuel filters (other than V.S.T. filter). We check and adjust timing at idle, check and adjust throttle and shift linkage. We check for proper adjustment of the engine oil injection system and check engine electrical wiring. We lubricate all linkages. On 4 strokes, Optimax, & H.P.D.I’s, we run a computer diagnostic analysis to check all manufacturers’ specifications.

Contact Us